MID 122 - CID 0254 - FMI 12
Conditions Which Generate This Code:
This diagnostic code is recorded when the Product Link detects a problem that is internal to the control module. This diagnostic code can only be caused if the Product Link control module is faulty. There are no serviceable parts within the control module.
Test Step 1. CHECK THE HARNESS CONNECTIONS.
- Disconnect and clean the contacts of the harness connectors.
- Reconnect all harness connectors.
- Turn the key start switch to the ON position.
- Operate the machine.
- Determine if CID 0254 FMI 12 diagnostic code is present by using the Electronic Technician.
Expected Result:
The CID 0254 FMI 12 diagnostic code is present.
Results:
- OK - The CID 0254 FMI 12 diagnostic code is present.
Repair: The problem has not been corrected. It is unlikely that the ECM is faulty. Perform the previous Steps again. If the cause of the diagnostic code is not found, replace the Product Link ECM. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace".
Stop.
- NOT OK - The CID 0254 FMI 12 diagnostic code is not present. The problem does not exist at this time. The initial problem was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation. Stop.
Caterpillar Information System:
Product Link 151/201 System Schematic
Product Link 151/201 MID 122 - CID 0254 - FMI 04
3054C Industrial Engine Fuel System - Prime
2002/10/01 A New Cylinder Head Group Is Available {1100}
3512B Marine Auxiliary Engine Engine Stopping
14H Motor Grader Machine Systems Circle Drive - Remove
2002/12/01 A Software Change Has Been Made to the Customer Communications Manual (CCM) {1926}
Product Link 151/201 Using the Diagnostic Indicator to Determine Diagnostic Codes
Product Link 151/201 MID 122 - CID 0168 - FMI 01
3054C Industrial Engine Model View Illustrations
3054C Industrial Engine Engine Description
G3500 Engines Water Temperature Regulator
G3520C and G3520E Generator Set Engines Electronic Control System Parameters
Product Link 151/201 MID 122 - CID 0269 - FMI 03
3054E Industrial Engine Balancer - If Equipped
Product Link 151/201 MID 122 - CID 0269 - FMI 04
Product Link 151/201 MID 122 - CID 1251 - FMI 03
Product Link 151/201 Position Reports Not Available
3054E Industrial Engine Air Inlet and Exhaust System
Product Link 151/201 Diagnostics and Events Not Available
Product Link 151/201 Operating Hours Discrepancy
Product Link 151/201 Reporting Interval Erratic
2002/11/01 A New Water Tank Group Is Used To Contain The Overflow Of Coolant {1354, 1377}
2002/10/01 Parts Manuals For The Following Engines Are Now Provided On A CD-ROM {1000, 7000}