Unit Injector Hydraulic Pump - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component. |
- Use a suitable lifting device to position unit injector hydraulic pump (2) and the O-ring seal on the engine. The weight of unit injector hydraulic pump (2) is approximately
27 kg (60 lb) . - Install bolts (5).
Show/hide table
Illustration 2 g01094363 - Install support bracket (4) on unit injector hydraulic pump (2).
Show/hide table
Illustration 3 g00884299 - Connect harness assemblies (3).
- Connect tube assembly (1) to unit injector hydraulic pump (2).
Show/hide table
Illustration 1 | g01094365 |
End By:
- Install the fuel transfer pump. Refer to Disassembly and Assembly, "Fuel Transfer Pump - Install".
Caterpillar Information System:
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0269 - FMI 03
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0190 - FMI 03
K65-12B Voltage Regulator High Voltage
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0190 - FMI 02
K65-12B Voltage Regulator Low Voltage
K65-12B Voltage Regulator General Information
3412E, C30 and C32 Marine Engines Unit Injector Hydraulic Pump - Remove
3056E Industrial Engine Electronic Control Module
3056E Industrial Engine Air Inlet Heater
K65-12B Voltage Regulator Voltage Droop Control
K65-12B Voltage Regulator Manual Voltage Control
3412E, C30 and C32 Marine Engines Engine Synchronize Switch Circuit - Test
3412E, C30 and C32 Marine Engines Switch Circuits - Test
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0334 - FMI 04 (for EUI Engines)
K65-12B Voltage Regulator Unstable Voltage
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0441 - FMI 12 (for MUI Engines)
K65-12B Voltage Regulator Knee Frequency - Adjust
G3500B Engines Humidity Sensor - Inlet Air
K65-12B Voltage Regulator Voltage Adjustment Range - Calibrate
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0566 - FMI 07 (for MUI Engines)
K65-12B Voltage Regulator Voltage Regulator - Test
G3600 Engines Pressure Switch - Electrohydraulic
3056E Industrial Engine Vibration Damper and Pulley
K65-12B Voltage Regulator Wiring Diagrams