Water Temperature Regulator - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Show/hide table
Illustration 1 g01101613 - Disconnect hose (2) and tube assembly (3).
- Remove bolts (4).
- Remove water temperature regulator housing (1).
Show/hide table
Illustration 2 g01101614 - Remove gasket (5) and water temperature regulator (6) from water temperature regulator housing (1).
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install water temperature regulator (6) and gasket (5) in water temperature regulator housing (1).
Show/hide table
Illustration 4 g01101613 - Position water temperature regulator housing (1).
- Install bolts (4).
- Connect hose (2) and tube assembly (3).
- Refill the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Show/hide table
Illustration 3 | g01101614 |
Caterpillar Information System:
3056E Industrial Engine Turbocharger
3500 Engines Mechanical Gauge - Test
C18 Generator Set Engine Rating Definitions
3056E Industrial Engine Fuel Filter Base
3412E, C30 and C32 Marine Engines System Overview
G3500 Generator Sets Emergency Stopping
G3500 Generator Sets Plate Locations and Film Locations
Break-In Procedure for New Cylinder Liners and Piston Rings{1215, 1216} Break-In Procedure for New Cylinder Liners and Piston Rings{1215, 1216}
2002/06/01 Corrections to Disassembly and Assembly, RENR1333, "3618 Engine" , "Piston and Connecting Rods - Install" {1214}
C27 and C32 Generator Set Engines Engine Oil Filter Base - Assemble
797B Off-Highway Truck Air System Control Valve (Air Dryer)
G3500 Generator Sets Overhaul (Major)
3056E Industrial Engine Crankcase Breather
C18 Marine Engines Sensors and Electrical Components
Electronic Modular Control Panel II+ (EMCP II+) Sensors
3056E Industrial Engine Water Pump
Electronic Modular Control Panel II+ (EMCP II+) Voltmeter/Ammeter Programming OP8
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Water Pump
Electronic Modular Control Panel II+ (EMCP II+) Engine Setpoint Verification OP9
Electronic Modular Control Panel II+ (EMCP II+) Diagnostic Codes
G3500 Generator Sets Voltage Regulators
C18 Marine Auxiliary Engine Model View Illustrations
Electronic Modular Control Panel II+ (EMCP II+) Relay Driver Module
Electronic Modular Control Panel II+ (EMCP II+) Synchronizing Lights Module