MID 047 - CID 0248 - FMI 09 CAT Data Link not communicating
Conditions Which Generate This Code:
The battery voltage to the Electronic Control Module (ECM) has been above 9 VDC for the last two seconds. The engine is not cranking. Communications with the VIMS and/or the VIDS has not been established for six seconds. Communication was lost for two or more seconds. The CID-FMI is logged in memory.
System Response:
The CID-FMI may be viewed on a display module or the Caterpillar Electronic Technician (ET). The features which receive inputs from the CAT Data Link are disabled.
Test Step 1. Perform the following test: CAT Data Link
Results:
- OK - Stop.
- REPAIRED, OK - Stop.
Caterpillar Information System:
37-MT, 41-MT, and 42-MT Series Starting Motors Pinion Clearance - Adjust
Product Link 151/201 Wiring Harness (Open Circuit) - Test
3034 Marine Engine Exhaust Manifold - Remove and Install
3126B Marine Engines System Overview
3034 Marine Engine Heat Exchanger - Install
3512B Marine Auxiliary Engine Analog Sensor - Calibrate
3456 Generator Sets Bearing - Lubricate
3512B Marine Auxiliary Engine Starting Motor System
3456 Generator Sets Generator Operation
3034 Marine Engine Heat Exchanger - Remove
3512B Marine Auxiliary Engine Secondary ECM/Personality Module
C-15 and C-16 Industrial Engines Engine Oil and Filter - Change
G3304 and G3306 Engines Basic Engine
3512B Marine Auxiliary Engine MID 047 - CID 0342 - FMI 07 Secondary Speed Sensor misinstalled
G3600 Engines Engine Design
3126B Marine Engines Glossary
3034 Marine Engine - Installation Guide Fuel System
3512B Marine Auxiliary Engine MID 047 - CID 0190 - FMI 07 Primary Speed Sensor misinstalled
3034 Marine Engine Inlet Manifold - Remove
3500B and 3500 Marine Propulsion Engines with EUI Option Centrifugal Oil Filter - Inspect
3034 Marine Engine Engine Oil Cooler - Remove
3034 Marine Engine Engine Oil Cooler - Install
3034 Marine Engine Marine Transmission Oil Cooler Core - Remove and Install
G3304 and G3306 Engines Restriction of Air Inlet and Exhaust