Turbocharger - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 5P-3931     | Anti-Seize Compound     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Apply Tooling (A) on the threads of the mounting studs for the turbocharger.
- Position the turbocharger gasket and turbocharger (4) on the exhaust manifold. Install nuts (3) .
Show/hide table
Illustration 1 | g01025729 |
- Tighten the locknuts that fasten the turbocharger to the exhaust manifold.
Tighten the locknut with the Spiralock thread to the following torque: ... 54 ± 5 N·m (40 ± 4 lb ft)
Tighten the standard locknut to the following torque: ... 70 ± 5 N·m (50 ± 4 lb ft)
- Connect tube assembly (2) .
Show/hide table
Illustration 2 | g01025728 |
- Connect hose assembly (1) .
Caterpillar Information System:
C4.4 Industrial Engine Fuel Conservation Practices
3126B Industrial Engine Vibration Damper
3054 Engine Engine Oil Pump - Inspect
3126B Industrial Engine Water Pump - Install
3126B Industrial Engine Engine Oil Pressure Sensor - Test
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Engine Speed/Timing Sensor
3054 Engine Cylinder Head - Inspect
C32 Petroleum Engines Diagnostic Flash Code Retrieval
3054, 3054B and 3056 Marine Engines Engine Valve Lash - Inspect/Adjust
3126B Industrial Engine Water Pump - Assemble
C-10 and C-12 Industrial Engines Lubrication System
C-15 and C-16 Industrial Engines Water Lines
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Injector Solenoids
G3516B and G3520B Generator Set Engines Engine Oil Cooler - Remove
C-15 and C-16 Industrial Engines Sensors and Electrical Components
3054 Engine Engine Oil Pressure - Test
2000/12/01 Recommended Procedure For Lubricating And Tightening The Bolts That Fasten The Counterweights To The Crankshaft {1231}
3054 and 3056 Marine Generator Set Engines Cooling System - Check - Overheating
3126B Industrial Engine Turbocharger - Remove
3054 and 3056 Marine Generator Set Engines Cooling System - Inspect
3054 and 3056 Marine Generator Set Engines Cooling System - Test
3054 Engine Cylinder Liner Projection - Inspect
C-15 and C-16 Industrial Engines Reference Material
3126B Engines Basic Engine