Fuel Filter Base - Remove
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 2P-8250 | Strap Wrench Assembly | 1 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Use Tool (A) and remove fuel filter (1).
Show/hide table
Illustration 2 g00612699 - Disconnect tube assembly (2) and tube assembly (4) from fuel filter base (5). Immediately cap all openings or plug all openings in order to prevent contamination.
- Remove bolts (3) that hold fuel filter base (5) to the mounting bracket. Remove fuel filter base (5).
Show/hide table
Illustration 1 | g00612695 |
Caterpillar Information System:
3054, 3054B and 3056 Marine Engines Cooling System Coolant (DEAC) - Change
3054, 3054B and 3056 Marine Engines Turbocharger - Remove
G3406 Engine Cylinder Liner Projection
3054, 3054B and 3056 Marine Engines Water Outlet Manifold - Remove
3054, 3054B and 3056 Marine Engines Cylinder Head - Remove - 3056 Engine
2000/10/01 New Combustion Feedback Cable Assembly Helps Prevent Moisture Damage {1563}
3126B Industrial Engine Flywheel
C7 Engines for Caterpillar Built Machines Water Pump
Special Instruction For Replacing a 173-7793 Droop Module With a 197-3531 Droop Module{4467} Special Instruction For Replacing a 173-7793 Droop Module With a 197-3531 Droop Module{4467}
G3408C and G3412C Engines Valve Lash and Valve Bridge Adjustment
3126B Industrial Engines Throttle Position Sensor Circuit - Test
CD44B and CD54B Vibratory Asphalt Compactors Engine Compartment - Clean
3126B and 3126E On-highway Engines Fuel Filter Base - Install
3126B and 3126E On-highway Engines Injection Actuation Pressure Control Valve - Remove
3126B and 3126E On-highway Engines Injection Actuation Pressure Control Valve - Disassemble
3126B and 3126E On-highway Engines Injection Actuation Pressure Control Valve - Assemble
3126B and 3126E On-highway Engines Injection Actuation Pressure Control Valve - Install
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Symbols
G3408C and G3412C Engines Engine Crankcase Pressure (Blowby) - Test
G3304 and G3306 Engines Compression
3054, 3054B and 3056 Marine Engines Aftercooler - Remove
3054, 3054B and 3056 Marine Engines Cooling System Coolant (ELC) - Change
3054 and 3056 Marine Generator Sets Cooling System Coolant Level - Check
G3304 and G3306 Engines Connecting Rod - Inspect