Fuel System - Prime
Show/hide table
图 1 | g00701304 |
燃油注油泵(典型示例) (1) 燃油注油泵 (2) 排气阀 |
燃油注油泵 (1) 位于油水分离器的顶部。
- 松开排气阀 (2) 。
- 向下按压燃油注油泵柱塞的顶部,再释放燃油注油泵的柱塞,从而操作燃油注油泵。 操作燃油注油泵柱塞可加注新的滤清器滤芯。 继续泵送,直到感觉阻力增大或燃油开始从排气阀流出。 阻力表明滤芯已充满了油。
- 拧紧排气阀。
- 起动发动机。 如果发动机不能起动,则需要继续排气。 如果发动机起动但持续缺火,仍需要继续排气。 如果发动机起动但持续排烟,仍需要继续排气。
- 如果发动机起动但运转不平稳,需持续在低怠速运转发动机。 继续以低怠速运转发动机,直到发动机运转平稳。
Caterpillar Information System:
3034 Engine for Caterpillar Built Machines Camshaft - Install
G3516B Engines +5V Sensor Voltage Supply
3126B Marine Engine Aftercooler Condensate Drain Valve - Inspect/Clean
2000/04/01 Revised Troubleshooting Module Available {1000}
3034 Engine for Caterpillar Built Machines Camshaft - Remove
2000/12/01 A New Electronic Actuator Is Used In Gas Pressure Regulator Groups That Are On Engines That Have Air/Fuel Ratio Control Systems {1716}
G3406 Engine Safety Messages
G3408 and G3412 Engines Model View Illustrations
G3516B Engines Engine Starts but Stalls Immediately
G3516B Engines Event Codes
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>115-5101</B> Generator through <B>121-6860</B> Generator
3114, 3116, and 3126 Engines Fuel Ratio Control - Adjust
3618 Engine Annunciator Panel - Inspect
3034 Engine for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
G3408 and G3412 Engines Gauges and Indicators
3114, 3116, and 3126 Engines Fuel System Pressure - Test
3176C and 3196 Engines for Caterpillar Built Machines Camshaft
G3406 Engine Model View Illustrations
3034 Engine for Caterpillar Built Machines Fan - Remove and Install
3114, 3116, and 3126 Engines Fuel Timing Dimension - Adjust
3034 Engine for Caterpillar Built Machines Crankshaft Gear - Remove and Install
584 and 584HD Forwarders General Hazard Information
325, 325B and 325L Excavators Part Number Location
325, 325B and 325L Excavators Final Drive Ring Gear Removal