Cylinder Head - Remove
Removal Procedure
Start By:
- Remove the valve cover base.
- Remove the rocker arms and the push rods.
- Remove the turbocharger.
- Remove the exhaust manifold.
- Remove the water outlet manifold.
- Remove the electronic unit injectors.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect the sensors from the engine wiring harness.
- Remove the sensors.
- Remove head bolts (1) .
Show/hide table
Illustration 1 | g00672645 |
- Attach a suitable lifting device to cylinder head (2). Remove cylinder head (2) from the cylinder block. The weight of cylinder head (2) is 135 kg (300 lb).
Show/hide table
Illustration 2 | g00672651 |
- Remove cylinder head gasket (3) and O-ring seals (4) from the cylinder block.
Caterpillar Information System:
3176C and 3196 Marine Engines Electronic Unit Injector Sleeve - Install
3176C and 3196 Marine Engines Inlet and Exhaust Valves - Remove and Install
3176C and 3196 Marine Engines Inlet and Exhaust Valve Springs - Remove and Install
2000/02/01 Correction To Troubleshooting, SENR5015-00 {1000}
3176C and 3196 Marine Engines Rocker Shaft and Pushrod - Remove
3176C and 3196 Marine Engines Valve Mechanism Cover - Remove and Install
3176C and 3196 Marine Engines Turbocharger - Install
2000/01/01 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
2000/01/01 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
Programming The Electronic Ignition System (EIS) Control Module For The Manifold Air Pressure (MAP) Sensor.{1408, 1901} Programming The Electronic Ignition System (EIS) Control Module For The Manifold Air Pressure (MAP) Sensor.{1408, 1901}
2000/01/17 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
3500 Generator Set Engines Auxiliary Drive Pulley
2000/01/01 New Idler Pulley Now Available {1358}
3512B Petroleum Engines High Coolant Temperature
2000/02/01 Shorter Bolts For Mounting The Radiator Support Brace To The Radiator Top Tank Are Used {1353}
3176C and 3196 Marine Engines Inlet and Exhaust Valve Guides - Remove and Install
3176C and 3196 Marine Engines Lifter Group - Remove and Install
3176C and 3196 Marine Engines Coolant Temperature Sensor - Remove and Install
3512B Petroleum Engines Altitude Derate Feature
3512B Petroleum Engines Crankcase Pressure
3512B Petroleum Engines Low Coolant Temperature
3512B Petroleum Engines Exhaust Temperature
3512B Petroleum Engines Fuel Filter Differential Pressure
3512B Petroleum Engines Engine Oil Filter Differential Pressure