CID 0100 FMI 13 Engine Oil Pressure calibration required
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects one of the following conditions:
- The engine oil pressure sensor has never been calibrated.
- Engine oil pressure is less than 35 kPa (5 psi) during a calibration attempt.
- Engine oil pressure is greater than 130 kPa (19 psi) during a calibration attempt.
- Engine oil pressure fluctuates more than 25 kPa (3.6 psi) during a calibration attempt.
- Engine oil pressure differs more than 27 kPa (4 psi) from atmospheric pressure during a calibration attempt.
- Active diagnostic codes are present for either the engine oil pressure sensor or the atmospheric pressure sensor during a calibration attempt.
System Response:
The ECM will log the diagnostic code. The diagnostic code may be viewed on a display module or on the Caterpillar Electronic Technician (ET).
- None
Test Step 1. Perform the following diagnostic procedure: Engine Sensor Open/Short Circuit - Test
Results:
- OK - STOP
Caterpillar Information System:
723PLUS Digital Speed Control Control Options
3176C Engine Maintenance Interval Schedule
3114, 3116 and 3126 MUI Engine Governors Throttle Lever (Types IV, V, VI, VII, and Some III) - Remove
3306B Industrial Engine Maintenance Interval Schedule
2000/01/01 New Shafts In Water Pump Groups Provide Increased Torsional Strength {1361, 1389}
3176C Industrial Engine Fan Drive - Install
3176C Industrial Engine Fan Drive - Remove
3512 Industrial Engine Flywheel
723PLUS Digital Speed Control Application
G3304 and G3306 Engines Test Tools for the Electrical System
723PLUS Digital Speed Control Declaration of Incorporation
723PLUS Digital Speed Control Introduction
2000/01/01 Cooling System Venting Procedure {1350}
3176C and 3196 Marine Engines Engine Oil Filter Base
723PLUS Digital Speed Control Hardware Options
3408E and 3412E Engines for Caterpillar Built Machines CID 0042 FMI 05 Injector Actuation Valve open circuit
3408E and 3412E Engines for Caterpillar Built Machines CID 0042 FMI 06 Injector Actuation Valve short to ground
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0110 FMI 03 Engine Coolant Temperature open/short to +batt
723PLUS Digital Speed Control Software Options
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0110 FMI 04 Engine Coolant Temperature short to ground
3408E and 3412E Engines for Caterpillar Built Machines CID 0164 FMI 03 Injector Actuation Pressure voltage high
2000/01/01 Corrections to Operation and Maintenance Manual, SEBU6759-02 , "Maintenance Interval Schedule" and Corrections to Operation and Maintenance Manual, SEBU6759-02 , "Maintenance Recommendations" {7519}
3408E and 3412E Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0174 FMI 03 Fuel Temperature open/short to +batt