Engine Oil Filter Housings - Remove
拆卸步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件描述     | 数量     |
A     | 138-7575     | 连杆支架     | 2     |
开始:
- 拆下发动机机油滤清器滤芯。 请参阅拆解和组装, "发动机机油滤清器滤芯 - 拆卸和安装"。
- 拆下发动机机油冷却器。 请参阅拆解和组装, "发动机机油冷却器 - 拆卸"。
- 拆下燃油滤清器壳体。 请参阅拆解和组装, "燃油滤清器壳体 - 拆卸"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
该步骤适用于左侧维修的机油滤清器壳体。 您的安排可能不同。
- 将工具 (A) 和适当的起吊设备连接到发动机机油滤清器壳体 (1) 。 发动机机油滤清器壳体 (1) 的重量约为 225 kg (496 lb)。
Show/hide table
图 1 | g01292977 |
- 在前壳体接头处断开管 (3) 和管 (4) 。
Show/hide table
图 2 | g01292983 |
- 确保所有管和软管组件都从发动机机油滤清器壳体 (1) 中断开。
- 拆下螺栓 (2) 。 从发动机中拆下发动机机油滤清器壳体 (1) 。
Caterpillar Information System:
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Pulse Width Modulated (PWM) Sensor - Test
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Starting Motor Magnetic Switch - Test
C9 Engines for Caterpillar Built Machines Unit Injector Sleeve - Install
3500 Engines for Caterpillar Built Generator Sets Fuel Pressure Regulator
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Speed Sensor (Engine) - Adjust
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Alarm Module Control - Adjust
G3304 and G3306 Engines Governor Linkage
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines AC Voltage Range - Adjust
G3304 and G3306 Engines Governor Linkage - Woodward PSG Governor For Turbocharged Engines
C-9 Engines for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
C9 Engines for Caterpillar Built Machines Unit Injector Sleeve - Remove
3126 Truck Engine Military Engine Lifting Bracket - Remove and Install
3406E On-Highway Engine Exhaust Manifold - Remove and Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Block Diagram of Generator Set Control
C9 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
3612 and 3616 Engines Engine Oil Filter Housings - Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines EMCP Electronic Control (AC Transformer Box) - Replace
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Relay Module - Replace
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines EMCP Electronic Control (Generator Set) - Replace
SR500 Generators Bearing (Spherical Roller) - Lubricate
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Typical Generator Abbreviations
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Symbols
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Reading DC Schematics
3054 Engine for Caterpillar Built Machines Crankshaft Rear Seal - Remove