Cylinder Liner
Usage:
(1) Bore in liner ... 5.751 ± .001 in.(146.08 ± 0.03 mm)
Use again maximum bore when measured near upper end of the wear surface of the cylinder liner ... 5.755 in.(146.18 mm)
(2) Thickness of flange on liner ... .4990 ± .0008 in.(12.675 ± 0.020 mm)
(3) Filler band.
Cylinder Liner Installation
Put liquid soap on bottom liner bore in block, on grooves in lower liner, and on O-rings. Install O-rings on liner. Put filler band (3) in engine oil for a moment and install on liner. Immediately install liner in cylinder block (before expansion of filler band).
NOTE: Make reference to GUIDELINE FOR REUSABLE PARTS; PISTONS AND CYLINDER LINERS, FORM NO. SEBF8001.
Caterpillar Information System:
G342 ENGINE Cylinder Block (Engines Without Spacer Plate)
G342 ENGINE Cylinder Block (Engines With Spacer Plate)
G342 ENGINE Water Temperature Regulators (9N2894 And 9S9160)
G342 ENGINE Water Temperature Regulators (4L7615)
G342 ENGINE Cooling System Pressure Cap (6L8617)
G342 ENGINE Water Pump Idler Gear
G342 ENGINE V-Belt Tension Chart
G342 ENGINE Fan Drive
G342 ENGINE Auxiliary Water Pump
G342 ENGINE Water Pump
G342 ENGINE Oil Filter Base (6L3714 Oil Filter Assembly)
G342 ENGINE Oil Filter Base (2S8877 Oil Filter Assembly)
G342 ENGINE Cylinder Liner Projection (With Spacer Plate)
G342 ENGINE Cylinder Liner Projection (Without Spacer Plate)
G342 ENGINE Pistons And Rings
G342 ENGINE Connecting Rod
G342 ENGINE Vibration Damper
G342 ENGINE Crankshaft
G342 ENGINE Flywheel Housing Bore
G342 ENGINE Flywheel Housing Runout
G342 ENGINE Flywheel
G342 ENGINE Flywheel Runout
G342 ENGINE Starter Motors
G342 ENGINE Starter Solenoids