Rocker Shaft and Pushrod - Remove
Start By:
- Remove the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove nuts (1) and bolt (2) from the rocker shaft assembly. Begin with the end brackets and move toward the center.
- Remove rocker shaft assembly (3).
- Remove the oil seal from the oil supply passage in the cylinder head.
Show/hide table
Illustration 2 g00635153 Typical example - Remove pushrods (4). Place an identification mark on the pushrods for installation.
Show/hide table
Illustration 1 | g00635152 |
Typical example |
Note: It is not necessary to remove the oil supply tube in order to remove the rocker shaft assembly and the pushrods.
Caterpillar Information System:
3054 Engine for Caterpillar Built Machines Housing (Front) - Install
3054 Engine for Caterpillar Built Machines Housing (Front) - Remove
SR4 HV and SR4B HV Generators Before Starting Engine
Generator Set Control Panel for Switchgear Conversion Component Location
3054 and 3056 Industrial and Generator Set Engines Engine Oil Cooler - Remove
3408E and 3412E Engines for Caterpillar Built Machines Fuel Transfer Pump
3606 and 3608 Engines General Information (Lubrication System)
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Disassemble
Generator Set Control Panel for Switchgear Conversion Clear/Mode Switch - Troubleshoot
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Install
Generator Set Control Panel for Switchgear Conversion Charging System - Test
Generator Set Control Panel for Switchgear Conversion CID 0263 FMI 04 Sensor Power Supply Voltage Below Normal - Test
SR4 HV and SR4B HV Generators Walk-Around Inspection
3054 Truck Engine Rocker Shaft and Pushrod - Install
3054 Engine for Caterpillar Built Machines Rocker Shaft - Disassemble
Generator Set Control Panel for Switchgear Conversion Cycle Crank - Adjust
3408E and 3412E Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
3054 Engine for Caterpillar Built Machines Rocker Shaft - Assemble
Generator Set Control Panel for Switchgear Conversion Cycle Crank
3054 Truck Engine Cylinder Head - Remove - 3054 and 3054B Engines
3054 Truck Engine Cylinder Head - Install - 3054 and 3054B Engines
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Assemble
G3408 and G3412 Engines Actuator Linkage
G3408 and G3412 Engines Carburetor Control Linkage