Track Roller (Single Flange)
Show/hide table
图 1 | g01580154 |
(A) 将橡胶挡块安装在轴中。 橡胶挡块的端部应与倒角端部平齐。 挡块可以后退到倒角以外 7 ± 7 mm (0.3 ± 0.3 in)。
(1) 组装前,必须清洁表面,确保没有防护涂层。
(2) 安装时,橡胶曲面密封和所有接触面必须清洁干燥。 组装前,在金属密封圈的接触面上涂抹一薄层 6V-4876 润滑剂 。 密封圈必须装配成方形。 橡胶曲面密封不能凸起也不能扭歪。
(3) 在密封的地方,用润滑剂将 O 形密封圈孔稍加润滑。
(B) 安装透明塞,使端部与橡胶挡块平齐。 透明塞可以伸出橡胶挡块之外 5 mm (0.2 in)。
履带支重轮轴的端隙
- 最低 ... 0.25 mm (0.010 in)
- 最高 ... 1.25 mm (0.049 in)
Caterpillar Information System:
3500 Spark Ignited Engines Engine Design
3406E On-Highway Engine Engine Oil Pressure Sensor - Remove and Install
3406E On-Highway Engine Coolant Temperature Sensor - Remove and Install
3406C (PEEC III) Truck Engines Glossary of Electronic Control Terms
3406E Engine Speed/Timing Sensor - Remove and Install
3176C Engine Cooling System Coolant (DEAC) - Change
G3300 Engines Engine Air Cleaner Service Indicator - Inspect
3406E and 3456 Generator Set Engines Fan Drive - Install
3406E On-Highway Engine Fan Drive - Remove
3406E On-Highway Engine Fan Drive - Assemble
3304B and 3306B Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
3406E On-Highway Engine Fan Drive - Disassemble
G3300 Engines Ignition System Spark Plugs - Inspect/Replace
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Engine Oil in Cooling System
G3500 Engines Camshaft
C-10 and C-12 Truck Engines Compression Brake
G3300 Engines Cooling System Coolant (DEAC) - Change
3176C and 3196 Industrial Engines Engine Oil Pressure Sensor - Remove and Install
3176C and 3196 Industrial Engines Speed/Timing Sensor - Remove and Install
3524B Engines for Off-Highway Trucks Fuel in Cooling System
3176C Engine Cooling System Coolant (ELC) - Change
3500B and 3500B High Displacement Generator Set Engines Oil Contains Coolant
3516B Engine for Caterpillar Built Machines Engine Has Early Wear
3524B Engines for Off-Highway Trucks Low Engine Oil Pressure