Water Pump - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use a new gasket and install elbow (5) .
Show/hide table
Illustration 1 | g00472590 |
- Put water pump (3) , the gasket and elbow (1) in position. Install two bolts (2) , two bolts (4) and the washers.
Show/hide table
Illustration 2 | g00472589 |
- Tighten hose clamp (5) .
Show/hide table
Illustration 3 | g00472588 |
- Fill the cooling system to the correct level. Refer to the Operation and Maintenance Manual for the correct fluid and the correct filling procedure.
Caterpillar Information System:
3306C Truck Engine Water Pump - Remove
3406E, C-10, C-12, C-15, C-16 Truck Engines Engine Oil and Filter - Change
3306C Truck Engine Water Temperature Regulator - Remove and Install
3306C Truck Engine Exhaust Manifold - Remove and Install
3406E, C-10 and C-12 Truck Engines Belt Tensioner - Inspect
G3612 and G3616 Engines Engine Design
3306C Truck Engine Turbocharger Wastegate - Remove and Install
G3612 and G3616 Engines Engine Design
3406E, C-10, C-12, C-15, C-16 Truck Engines Engine Oil Level Gauge - Calibrate - C-10 and C-12 Engines Only
3406E, C-10, C-12, C-15, C-16 Truck Engines Cylinder Head Grounding Stud - Inspect/Clean/Tighten
3406E, C-10, C-12, C-15, C-16 Truck Engines Engine Oil Level - Check
G3606 and G3608 Engines Air Lines
3304B and 3306B Engines for Caterpillar Built Machines Water Pump - Disassemble
3304B and 3306B Engines for Caterpillar Built Machines Water Pump - Assemble
3408E and 3412E Engines for Caterpillar Built Machines Bearing Clearance - Check
3306B Industrial Engine Piston Cooling Jets - Remove and Install
3176C and 3196 Industrial Engines Belt Tensioner
3306C Truck Engine Crankshaft - Remove
3306C Truck Engine Crankshaft - Install
3176C and 3196 Engines for Caterpillar Built Machines Engine Oil Filter Base
G3612 and G3616 Engines Air Starting System
G3606 and G3608 Engines Lubrication System
Electronic Modular Control Panel II (EMCP II) for EUI Engines Component Location
Electronic Modular Control Panel II (EMCP II) for EUI Engines EMCP Electronic Control (Generator Set)