Start By:
- Remove the electronic control module.
NOTICE |
---|
Before beginning ANY work on the fuel system, refer to Operation and Maintenance Manual, "General Hazard Information and High-Pressure Fuel Lines" for safety information. Refer to System Operation, Testing and Adjusting, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system. |
Personal injury can result from hot coolant, steam and alkali. At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns. Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand. Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns. Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes. |
- Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedure.
Show/hide table
Illustration 1 g02193293 - Disconnect plastic tube assembly (1) from crankcase breather (2). Disconnect plastic tube assembly (5) from crankcase breather canister (2) and crankcase breather valve (8).
- Cut the cable straps for engine wiring harness (3) that secure the wiring harness assembly to engine oil cooler (6).
- Remove bolt (4) and remove bracket (7) from engine oil cooler (6). Position the bracket away from the engine oil cooler
- Remove bolt (10) from the bracket for the tube assembly. Loosen nut (9) and remove tube assembly.
- Remove seal (11) (not shown) from the tube assembly.
Show/hide table
Illustration 2 g02194313 - Remove bolt (12) from bracket (13). Position bracket (13) away from the engine oil cooler.
- Remove bolts (14) from oil cooler (6).
Note: The bolts are different lengths. Note the position of the different bolts. Note the location and the orientation of the brackets for the tube assemblies.
- Remove engine oil cooler assembly (6) from the cylinder block.
- Remove gasket (15) (not shown).
Show/hide table
Illustration 3 g02193294 - If necessary, follow Step 11.a through Step 11.c to disassemble the engine oil cooler.
- Remove nuts (18) from the assembly of engine oil cooler (6).
- Remove cooler matrix (16) from housing (19).
- Remove gaskets (17).
- Install engine oil cooler (6) in the reverse order of removal.
- Tighten nuts (18) to a torque of
44 N·m (32 lb ft) . - Tighten bolts (14) to a torque of
22 N·m (195 lb in) .
- Tighten nuts (18) to a torque of