Illustration 1 | g00295950 |
(1) Tighten the bolts of the flywheel housing to the following torque:
- The M10 bolts for the cast iron flywheel housing ...
44 N·m (32 lb ft) - The M12 bolts that are stamped "8.8" for the cast iron flywheel housing ...
75 N·m (55 lb ft) - The M10 bolts that are stamped "10.9" for the cast iron flywheel housing ...
63 N·m (46 lb ft) - The M12 bolts that are stamped "10.9" for the cast iron flywheel housing ...
115 N·m (85 lb ft) - The M12 bolts that are stamped "8.8" for the cast iron flywheel housing ...
- The M10 bolts that are for the aluminum flywheel housing ...
70 N·m (52 lb ft)
(2) The maximum temperature for heating the flywheel ring gear for installation ...
(3) Tighten flywheel bolts to the following torque: ...
Illustration 2 | g00295952 |
Face Runout Check |
Maximum permissible face runout of the flywheel housing ...
Refer to Testing and Adjusting, "Flywheel and Flywheel Housing" for the correct procedure to measure the runout.
Illustration 3 | g00295954 |
Bore Runout Check |
Maximum permissible bore runout of the flywheel housing ...
Refer to Testing and Adjusting, "Flywheel and Flywheel Housing" for the correct procedure to measure the runout.
Illustration 4 | g00295955 |
Face Runout Check |
Maximum permissible bore runout of the flywheel housing ...
Refer to Testing and Adjusting, "Flywheel and Flywheel Housing".
Illustration 5 | g00295956 |
Outside Diameter Runout Check |
Maximum permissible bore runout of the flywheel housing ...
Refer to Testing and Adjusting, "Flywheel and Flywheel Housing" for the correct procedure to measure the runout.