Cooling System Coolant (ELC) - Change
在长效冷却液(ELC)被放掉和更换时清洁冷却系统,只需要净水。
排放
- 发动机停机,使发动机冷却下来。 缓慢地松开冷却系统加注口盖,以释放掉所有压力。 拆下冷却系统加注口盖。
- 打开冷却系统放水阀(如有配备)。 如果冷却系统没有配备排放阀,拆下冷却系统排放塞。
使冷却液放出。
Show/hide table
图 1 | g00285349 |
排放螺塞 |
Show/hide table
注意 |
---|
正确地处置用过的发动机冷却液或回收再利用。 回收冷却液使之在发动机冷却系统中再利用的方法有多种。 卡特彼勒唯一接受的回收使用过的冷却液的方法是完全蒸馏程序。 |
关于用过冷却液的处理和回收资料,请与 Caterpillar 代理商或 Caterpillar 维修技术组联系:
伊利诺伊州外: 1-800-542-工具伊利诺伊州内: 1-800-541-工具加拿大: 1-800-523-工具冲刷
- 用清洁水冲刷冷却系统以便清除所有碎屑。
- 关闭排放阀(如有配备)。 清洁排放塞。 安装放油塞。 有关正确扭矩的更多资料,请参阅操作和保养手册, "扭矩规格"。
- 用清洁的水加注冷却系统。 安装冷却系统加注口盖。
Show/hide table
注意 |
---|
向冷却系统加注时,速度不要快于每分钟19升(L) (5美加仑(US gal)),以避免发生气阻。 |
- 起动发动机并在低怠速运转,直到温度达到 49 至 66 °C (120至150 °F)。
- 发动机停机,使发动机冷却下来。 缓慢地松开冷却系统加注口盖,以释放掉所有压力。 拆下冷却系统加注口盖。 打开放水阀(如有配备)或拆下冷却系统排放塞。 使水放出。 用清洁的水冲洗冷却系统。 关闭排放阀(如有配备)。 清洁排放塞。 安装放油塞。 有关正确扭矩的更多资料,请参阅操作和保养手册, "扭矩规格"。
加注
- 使用冷却液或防冻液加注冷却系统。 有关冷却系统技术参数的更多资料,请参阅操作和保养手册。 不要安装冷却系统加注口盖。
Show/hide table
注意 |
---|
向冷却系统加注时,速度不要快于每分钟19升(L) (5美加仑(US gal)),以避免发生气阻。 |
- 将变速箱置于空档位置。 起动发动机并在低怠速下运转。 将发动机转速提高到1500rpm。 以 1500 rpm 运转发动机 1 分钟以便排出发动机缸体腔室中的空气。 关闭发动机。
- 检查冷却液液位。 把冷却液液位保持在加注管底部以下 13 mm (0.5 in) 以内。 把冷却液液位保持在距离观察窗 (如有此设备)上的正确液位 13 mm (0.5 in) 的范围内。
- 清理冷却系统加注口盖。 检查加注口盖的垫片。 如果加注口盖上的垫片损坏,废弃原来的冷却系统加注口盖并安装新的冷却系统加注口盖。 如果加注口盖上的垫片没有损坏,使用 9S-8140 加压泵 以便加压测试冷却系统加注口盖。 冷却系统加注口盖的正确压力刻印在冷却系统加注口盖的表面。 如果冷却系统加注口盖无法保持正确压力,安装新的冷却系统加注口盖。
- 起动发动机。 检查冷却系统是否渗漏或工作温度是否正常。
Caterpillar Information System:
3054 and 3056 Industrial and Generator Set Engines Cooling System Coolant (DEAC) - Change
3176C and 3196 Marine Engines Main Bearing Journal
3176C and 3196 Marine Engines Connecting Rod Bearing Journal
3054 and 3056 Industrial and Generator Set Engines Alternator and Fan Belts - Inspect/Adjust/Replace
3176C and 3196 Marine Engines Connecting Rod Bearing Journal
3406E Truck Engine Camshaft
3500B and 3500B High Displacement Generator Set Engines Crankshaft Position for Fuel Injector Adjustment and Valve Lash Setting
3054 and 3056 Industrial and Generator Set Engines Refill Capacities
3176C Engine Coolant Temperature Sensor
3406E Truck Engine Engine Design
3208 Marine Engine Fuel Related Components in Cold Weather
3176C and 3196 Industrial Engines Speed/Timing Sensor
C15 Petroleum Generator Set Engines Water Temperature Regulator
G3300 Engines Cooling System Coolant Level - Check
3054 and 3056 Industrial and Generator Set Engines Engine Air Cleaner Element (Single Element) - Replace
3208 Marine Engine Engine Air Cleaner Service Indicator - Inspect - If Equipped
3406E Truck Engine Fuel Transfer Pump
3406E Truck Engine Engine Oil Pump
3054 and 3056 Industrial and Generator Set Engines Engine Crankcase Breather - Clean
3524B Engines for 797 and 797B Off-Highway Trucks Electronic Control System Components
3306B Industrial Engine Coolant Conditioner Base
3406E Truck Engine Cylinder Head Valves
3176C and 3196 Industrial Engines Camshaft
3406E Truck Engine Valve Mechanism Cover