Start By:
- Tilt the cab.
At operating temperature, the hydraulic tank is hot and under pressure. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Loosen retaining nut (1) and disconnect tee (2) from pump control valve (4).
- Remove four bolts (3) that secure pump control valve (4) to the piston pump. Remove the pump control valve from the piston pump.
Show/hide table
Illustration 2 g00770052 - Remove three O-ring seals (5) from pump control valve (4).
Illustration 1 | g00770050 |
- Inspect all parts and clean all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
Show/hide table
Illustration 3 g00770052 - Install three O-ring seals (5) into pump control valve (4).
Show/hide table
Illustration 4 g00770050 - Position pump control valve (4) to the piston pump and install four bolts (3).
- Connect tee (2) to the valve and tighten retaining nut (1).
End By:
- Lower the cab.