Using Cat® Electronic Technician (Cat ET)
The Cat Electronic Technician (Cat ET) service tool is used in order to access the calibration procedures. For more information, refer to the manual that was provided with the Cat ET.
The calibration menu is used in order to compensate for the differences in the mechanical components and the electrical components. The calibration should be performed if the ECM has been replaced or the ECM was removed. The calibration should be performed if components have been replaced or removed. Perform all calibrations that are applicable.
Connect the Cat ET to the machine. After communication has been established, the Cat ET will list the electronic control modules that are on the machine.
Note: The ECM must detect specific conditions before the calibration procedure is started. If a step is not met, the calibration procedure is aborted.
- Connect to Cat ET.
Show/hide table
Illustration 1 g03720948 ECM Summary screen - Select "Service" from the main menu.
Select "Calibrations" from the drop-down menu.
Show/hide tableIllustration 2 g03720959 "Service" Drop-down selection - Select the function you want to calibrate.
Show/hide table
Illustration 3 g03720996 Available Calibrations screen Show/hide tableIllustration 4 g03720999 Typical Calibrations Show/hide tableIllustration 5 g03721002 Example Calibration screen - Follow the instructions provided on the screen.