Personal injury or death can result from sudden machine movement. Sudden movement of the machine can cause injury to persons on or near the machine. To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine. |
Injury to personnel can result if they are not in the operator's view. Allow only essential personnel near the machine, and make sure the personnel are in the operator's view when testing, to prevent injury. Make sure checks are done in an open area. |
Personal injury can result from rotating and moving parts. Stay clear of all rotating and moving parts. Never attempt adjustments while the machine is moving or the engine is running unless otherwise specified. The machine must be parked on a level surface and the engine stopped. |
- Drive the machine to a smooth, horizontal surface.
Show/hide table
Illustration 1 g01360657 - Move propulsion lever (3) to the NEUTRAL position.
- Rotate speed dial (2) to the MINIMUM position.
- Move parking brake switch (1) to the ON position.
Show/hide table
Illustration 2 g01360659 - Move screed lift switch (4) to the RAISE position. Completely lift the screed.
Show/hide table
Illustration 3 g01360660 - Engage screed lock mechanism (5) on both sides of the machine.
- Move screed lift switch (4) to the FLOAT position.
Show/hide table
Illustration 4 g01360662 - Move throttle control switch (6) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
- After the engine reaches low idle, move engine start switch (7) to the OFF position.
- Move engine start switch (7) to the ON position. Do not start the engine.
Show/hide table
Illustration 5 g01360664 - Press home key (8).
Show/hide table
Illustration 6 g01360665 - Press down key (9) until "Service" is highlighted on the display screen.
- Press "OK" key (10).
Show/hide table
Illustration 7 g01360668 - Press down key (9) until "Calibrations" is highlighted on the display screen.
- Press "OK" key (10).
Show/hide table
Illustration 8 g01360689 - Press down key (9) until "Lt Steering Wheel" is highlighted on the display screen.
- Press "OK" key (10).
- Press "OK" key (10) in order to begin the calibration.
Show/hide table
Illustration 9 g01360690 Show/hide tableIllustration 10 g01360692 - Move operator station select switch (11) to the LEFT position.
- Press "OK" key (10).
Show/hide table
Illustration 11 g01360726 - Hold left steering wheel against the left spring. Do not compress the spring.
- Press "OK" key (10).
Show/hide table
Illustration 12 g01360728 - Hold left steering wheel against the right spring. Do not compress the spring.
- Press "OK" key (10).
Show/hide table
Illustration 13 g01360729 - The display should now read "CALIBRATION COMPLETE". Push back key (12) in order to return to calibration screen.
- Push home key (8) in order to exit the calibration screen.
- Push home key (8) to exit the calibration screen.
- Move engine start switch (7) to the OFF position.