Removal Procedure
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
ZZ     | 6V-9508     | Face Seal Plug (11/16 - 16 THD)     | 2     |
6V-9829 | Cap Assembly (11/16 - 16 THD)     | 2     |
Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed. Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death. Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder. |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Extend the screed to the right.
- Remove bolt (1) .
Illustration 1 | g01068374 |
- Retract the extender cylinder (2) .
- Disconnect hose assemblies (3) .
Illustration 2 | g01068376 |
- Remove bolts (4) .
Illustration 3 | g01068377 |
- Remove support (5) .
- Attach a suitable lifting device to extender cylinder (2). Remove extender cylinder (2) from the screed. The weight of the extender cylinder is approximately 36 kg (79 lb).
Illustration 4 | g01068378 |
Installation Procedure
- Attach a suitable lifting device to extender cylinder (2). Install extender cylinder (2) in the screed.
Illustration 5 | g01068378 |
- Install support (5) .
Illustration 6 | g01068377 |
- Install bolts (4) .
- Connect hose assemblies (3) .
Illustration 7 | g01068376 |
- Extend extender cylinder (2) .
Illustration 8 | g01068374 |
- Install bolt (1) .
- Retract the screed.