Gear Pump (Steering) - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position steering pump (1) on the engine and install bolts (3) .
Show/hide table
Illustration 1 | g01043623 |
- Connect hose assemblies (2) to steering pump (1) .
- Fill the hydraulic tank with hydraulic oil. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change". The capacity of the hydraulic tank is approximately 26 L (6.9 US gal).
- Close the engine enclosure.
End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Caterpillar Information System:
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Gear Pump (Steering) - Assemble
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Gear Pump (Steering) - Disassemble
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Gear Pump (Steering) - Remove
CP-323C and CS-323C Paving Compactors Cooling System Coolant (ELC) - Change
2004/03/29 Special Instruction, REHS1037 , "Installation Instructions for the Electric Fuel Priming Pump on Caterpillar Equipment With the 24 Volt System" has been Revised {1258}
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarrier Hydraulic System Relief Valve (Line) - Test and Adjust
C15 On-Highway Engine Engine Oil Pump - Assemble
C15 On-Highway Engine Engine Oil Pump - Disassemble
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pump - Install
3524B Engines for 797 and 797B Off-Highway Trucks Cold Mode Operation
CP-323C and CS-323C Paving Compactors Circuit Breakers - Reset
CP-323C and CS-323C Paving Compactors Battery or Battery Cable - Inspect/Replace
2004/02/16 Lighting Group Uses New Seals and Bolt-On Covers {1429, 1434}
C15 and C18 Generator Set Engines Inlet and Exhaust Valve Springs - Remove and Install
446D Backhoe Loader Engine Crankcase Breather - Clean
2004/02/16 Correction to Testing and Adjusting , "Piston Pump Neutral - Test and Adjust" {5070}
446D Backhoe Loader Engine Air Precleaner - Clean
446D Backhoe Loader Engine Oil Level - Check
Conversion of High Flow Work Tools For Operation on High Flow Skid Steer Loaders and Multi Terrain Loaders{1408, 5057, 7553} Conversion of High Flow Work Tools For Operation on High Flow Skid Steer Loaders and Multi Terrain Loaders{1408, 5057, 7553}
CB-214E, CB-224E and CB-225E Paving Compactors Isolation Mounts - Inspect
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Metering Pump (Steering) - Remove and Install
446D Backhoe Loader Axle Oscillation Bearings - Lubricate
C15 and C18 Generator Set Engines Inlet and Exhaust Valves - Remove and Install
446D Backhoe Loader Engine Oil Sample - Obtain