Usage:
(1) Tighten the bolts in steps to a torque of ... 47 ± 9 N·m (35 ± 7 lb ft)
(2) Tighten the bolts in steps to a torque of ... 12 ± 3 N·m (9 ± 2 lb ft)
Pressure Regulating Valve For Air Starting Motor
(1) Adjusting bolt.
(2) Inlet pressure ... 1725 kPa (250 psi)
Maximum permissible pressure ... 3100 kPa (450 psi)
(3) Outlet pressure ... 620 to 760 kPa (90 to 110 psi)
Electric
9X4452
Rotation-viewed from drive end ... clockwise
No load conditions at 25°C (77°F):
Speed ... 3300 rpm minimum
Current draw ... 80A maximum
Voltage ... 24V
(1) Torque for 1/2 - 13 terminal nuts ... 27 to 34 N·m (20 to 25 lb ft)
(2) Torque for 10 - 32 terminal nuts ... 2.25 ± .25 N·m (19.912 ± 2.212 lb in)
(3) Tighten nut to a torque of ... 17.5 ± 2.5 N·m (12.87 ± 1.84 lb ft)
(4) Tighten nut to a torque of ... 1.5 ± 0.4 N·m (13.27 ± 3.54 lb in)
Solenoid
Current consumption (draw) at 25°C (77°F):
Pull-in current at 24V ... 103A
Hold-in current at 24V ... 19A
8C3644, 8C3649
Rotation as seen from drive end ... Clockwise
No load conditions at 25°C (77°F):
Speed (rpm) ... 5500 to 8000
Current (amps) ... 50 to 85A
Voltage ... 20.0V
(1) Torque for terminal nuts ... 30 ± 3 N·m (22 ± 2 lb ft)
(2) Torque for screws holding nose housing to lever housing ... 20 ± 2 N·m (177 ± 18 lb in)
Clearance between pinion and housing pinion clearance) ... 8.3 to 9.9 mm (.33 to .39 in)
7T0794, 7T0795
Rotation as seen from drive end ... Clockwise
No load conditions at 25°C (77°F):
Speed (rpm) ... 5500 minimum
Current (amps) ... 140A maximum
Voltage ... 24.0V
(1) Intermediate housing.
(2) Bracket.
(3) Torque for small solenoid terminal nut ... 2.25 ± 0.25 N·m (20 ± 2 lb in)
(4) Torque for large terminal nuts ... 30 ± 3 N·m (265.5 ± 26.5 lb in)
(5) Bolt. Tighten to a torque ... 8.5 ± 1.5 N·m (75 ± 13 lb in)
The pinion clearance is correct when the solenoid position dimension (X) is 62.50 + 0.20 - 0.50 mm (2.461 + .008 - .020 in) from intermediate housing (1). The following procedure is used to adjust the solenoid position:
a. Loosen bolts (5) and move the solenoid until distance (X) is correct. Bracket (2) has elongated holes.
b. Tighten bolts (5) after the adjustments is correct to a torque of ... 8.5 ± 1.5 N·m (75 ± 13 lb in)