Valve Guides
Usage:
Remove Valve Guides
Start By:
a. remove valves
1. Remove valve guides with Tool (A).
Install Valve Guides
1. Put clean engine oil on the outside of the valve guides.
2. Use Tool (A) to install the valve guides. Install the valve guides so that dimension (X) is 32.3 ± 0.8 mm (1.27 ± .03 in). The inside diameter of the guides must be 9.479 ± 0.020 mm (.3732 ± .0008 in). The maximum diameter for used guides is 9.545 mm (.3758 in).
End By:
a. install valves
Caterpillar Information System:
3408C & 3412C INDUSTRIAL ENGINES Valves
3408C & 3412C INDUSTRIAL ENGINES Cylinder Head
3408C & 3412C INDUSTRIAL ENGINES Valve Lifters & Push Rods
3408C & 3412C INDUSTRIAL ENGINES Rocker Shaft Assembly
3408C & 3412C INDUSTRIAL ENGINES Valve Covers
3408C & 3412C INDUSTRIAL ENGINES Exhaust Manifold
3408C & 3412C INDUSTRIAL ENGINES Turbocharger (Engine With Four Turbochargers)
3408C & 3412C INDUSTRIAL ENGINES Turbochargers (3408 Engine)
3408C & 3412C INDUSTRIAL ENGINES Fuel Ratio Control
3408C & 3412C INDUSTRIAL ENGINES Aftercooler Core
3408C & 3412C INDUSTRIAL ENGINES Testing And Adjusting
3408C & 3412C INDUSTRIAL ENGINES Systems Operation
3408C & 3412C INDUSTRIAL ENGINES Bridge Dowels
3408C & 3412C INDUSTRIAL ENGINES Valve Seat Inserts
3408C & 3412C INDUSTRIAL ENGINES Spacer Plates
3408C & 3412C INDUSTRIAL ENGINES Vibration Damper & Pulley
3408C & 3412C INDUSTRIAL ENGINES Crankshaft Front Seal & Wear Sleeve
3408C & 3412C INDUSTRIAL ENGINES Timing Gear Cover
3408C & 3412C INDUSTRIAL ENGINES Camshaft
3408C & 3412C INDUSTRIAL ENGINES Camshaft Bearings
3408C & 3412C INDUSTRIAL ENGINES Timing Gears
3408C & 3412C INDUSTRIAL ENGINES Crankshaft Rear Seal & Wear Sleeve
3408C & 3412C INDUSTRIAL ENGINES Flywheel
3408C & 3412C INDUSTRIAL ENGINES Flywheel Housing